Toshiba ETH-100 Manuale Utente

 

  

29

 

 
Show:  This command displays current configuration information.  Some of 
this information (IP Address, Subnet Mask and Gateway) is configurable via 
the “set” command.  The “Firmware Version” field indicates the current 
application firmware version of the ETH-100.  The “File system Version” field 
indicates the current file system version of the ETH-100.  Refer to Figure 15. 
 

 

 
Xmodem:  The “xmodem” command allows point configuration files to be 
transferred between the ETH-100 and a PC.  Refer to section 12.3.1 for more 
information about point mapping.  The xmodem command only applies to the 
serial console (MMI port), since xmodem is a serial protocol. 
 
Whenever a point configuration is created, it is highly recommended that a 
backup copy of the point configuration file be downloaded from the ETH-100 to 
a PC.  One reason for this is in case it becomes necessary to restore the file to 
the ETH-100’s file system later (such as if the ETH-100’s internal backup 
battery becomes exhausted and requires replacement).  Another reason is that 
it may be desirable to load multiple interface units with the same configuration.  
A downloaded point file can be uploaded to any ETH-100, allowing the user to 
clone multiple units with the same configuration. 
 
Two different variations of the Xmodem protocol are supported (CRC and 
Checksum) for those serial communications packages that only support one or 
the other.  However, some programs (such as HyperTerminal) can