Toshiba portege m400 Manuale Utente

Pagina di 298
User’s Manual
D-3
S-registers
S5
Command line editing character (user defined)
This register sets the character recognized as a backspace and 
pertains to asynchronous only. The modem will not recognize the 
backspace character if it is set to a value that is greater than 32 
ASCII. This character can be used to edit a command line. When 
the echo command is enabled, the modem echoes back to the 
local DTE the backspace character, an ASCII space character, 
and a second backspace character. This means a total of three 
characters are transmitted each time the modem processes the 
backspace character.
Range: 0-127, ASCII decimal
Default: 8 (backspace)
Units:
ASCII
S6
Wait before dialing
This register sets the length of time, in seconds, that the modem 
must wait (pause) after going off-hook before dialing the first digit 
of the telephone number. The modem always pauses for a 
minimum of two seconds, even if the value of S6 is less that two 
seconds. The wait for dial tone call progress feature (W dial 
modifier in the dial string) will override the value in register S6. 
This operation, however, may be affected by some ATX options 
according to country/region restrictions. In some countries/regions, 
S6 will set dial tone detect time.
Range: 3-255
Default: 3
Units:
seconds
S7
Connection completion time-out
This register sets the time, in seconds, that the modem must wait 
before hanging up because carrier is not detected. The timer is 
started when the modem finishes dialing (originate), or goes off-
hook (answer). In originate mode, the timer is reset upon detection 
of an answer tone if allowed by county restriction. The timer also 
specifies the wait for silence time for the @ dial modifier in 
seconds. S7 is not associated with the W dial modifier.
Range: 1-255
Default: 50
Units:
seconds