Sonic Alert SBA475SS Manuale Utente

12

11

7

4

5

6

3

2

1

1)   Function Switch                                              7)    Battery Compartment  

     2)   Back light Hi/Lo Dimmer                              8)    Time Set Knob   

     3)   Snooze Button                                                 9)    Alarm Set Knob 

     4)   Volume Control                                              10)  Back light On/Off 

     5)   Flashing Light Display                                  11)  AC Power Input

     6)   Tone Control                                                   12)  Vibrator Input 

   Attach the AC power supply input to the back of clock at AC-9V IN (11) next to the VIBRATOR

   input, smaller input of the two. 

 IMPORTANT: do not confuse"AC POWER INPUT"(11) with the "VIBRATOR INPUT"(12)

   1) Turn the Time Set Knob (8) clockwise until hour and minute hands show desired time.

           

   1) Turn the Alarm Knob (9) clockwise until alarm hand is at the desired time.

       

   To enable the alarm function, slide the "FUNCTION SWITCH" (1) up to the position that you desire 

   to wake to, you can choose "VIB" for bed shaker, "BUZZ" for sound, and  "VIB/BUZZ" for  both. 

 whichever function you choose to wake to, will be the same function for both alarms. When 

               the alarm sounds, the Flashing Light Display (4) and the back light will flash until the alarm 

               is stopped.

   SNOOZE button (3) - press after alarm has sounded.  The alarm will be turned off for 4 minutes for  

   extra sleep.  The alarm will come back again after 4 minutes.  

   Alarm can be shut off by sliding the function switch  (1) to off position.

   

   To adjust the "VOLUME", turn the volume wheel (4) located on right side of the clock.

   

   To adjust the "TONE", turn the tone wheel (6) located on right side of the clock to the desired tone 

   sound. 

   1)   Attach the bed shaker jack to the side of clock at VIBRATOR input (12).

   2)   To turn on vibrator slide FUNCTION switch (1) to VIB or VIB/BUZZ position.

   3)   Place vibrator under mattress or pillow.

   The blue back light can be turned on or off by using switch (10) located at the back of the clock.  

   The brightness of the back light can be adjusted by using the dimmer switch (2) at the side of the 

   clock. 

   To use battery backup, you can install a 1.5-volt AA size alkaline battery at the bottom of the clock 

   located under the  battery cover (7).  Note the back light, vibrator and sound will not operate during

   power failure, your alarm and time setting will be saved when power is restored.  

      

10

9

8

Figure B

Night Light Section: amended some wordings