Edelbrock 3826 Manuale Utente

Rev. 5/02

Brochure #63-0099

Throttle Body Gasket (up )

forward

Figure 1 – Throttle Body Gasket and EGR Plate Gasket

EGR Gasket (up )

Edelbrock Corporation

2700 California Street

Torrance, California 90503

Tech Line: (800)-416-8628

Office: (310) 781-2222

c. Disconnect the idle speed control solenoid connector.
d. Run the engine until it is at operating temperature.
e. Turn the throttle plate hard stop screw counter clockwise until the lowest

factory idle speed setting (625 rpm) is obtained. Increased idle speed may be
required if the engine has been modified.

f. Turn the engine off and reconnect the idle speed control connector.

12.

CHECK THE THROTTLE POSITION SENSOR VOLTAGE: Turn the ignition switch to

the “ON” position but do not start the engine. Using a digital volt/ohmmeter, measure
the voltage between the Dark Green/Light Green wire and the Black wire. Be sure the
voltage is between 0.8v and 1.0v. This voltage can be adjusted by loosening the two

screws and slightly rotating the throttle position sensor. If necessary, elongate the
mounting holes on the throttle position sensor to obtain this specification. (See Photo

#6).

Note: For optimum performance on 1986-1988 vehicles equipped with speed-

density system, we strongly recommend mass-airflow conversion. Kits

are available from Ford performance parts and other aftermarket outfits.

EGR Plate Kit Contents:

1- Spacer casting
1- 5/16" x 1-1/2" carb stud

1- 3/8" x 1-1/2" stud
1- 5/16" split lock washer

1- 3/8" split lock washer

1- 5/16"-24 hex nut
1- 3/8"-24 hex nut

1- Gasket; EGR plate to manifold
1- Gasket; throttle body to EGR plate
1- Gasket; EGR valve

Throttle Body Kit Contents:

1-Throttle body assembly
1-Gasket; throttle body to EGR plate

1-Gasket; idle solenoid to throttle body