Havis-Shields c-tm-imp-1 Manuale Utente
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Remove partial OEM cup-holder/console located on the transmission hump.
2. Remove partial OEM cup-holder/console located on the transmission hump.
Note: Do not remove metal housing attached to this partial console. This piece is meant to strengthen the
vehicles crumple zone and must not be removed.
vehicles crumple zone and must not be removed.
INSTALLATION:
View of partial OEM
console removed
Attach rear extrusion bracket
(CM001380) to vehicle using
factory screws from, “partial
console,” removal.
Sub-assemble C-B43 (only the
piece shown), 18” portion of
trak, extrusion adapter bracket,
rear extension bracket and 12”
portion of trak
Attach C-B43 transmission
hump bracket to 18” section
of extrusion using (4) ¼” x
¾” bolts and serrated nuts.
(7/16” Wrench)
Attach extrusion adapter
bracket to 18” section of
bracket to 18” section of
extrusion using (2) ¼” x
¾” bolts and serrated nuts.
(7/16” Wrench)
Attach the extrusion adapter
bracket to the 12” section of
bracket to the 12” section of
extrusion using (2) ¼” x ¾”
bolts and serrated nuts.
(7/16” Wrench)
C-TM-IMP-1_INST_11-08
2