Meridian Audio 541 Manuale Utente

Selecting a source

The display shows the source,

and volume setting; for example:

CD        65

Then after a short delay the display shows the preset associated

with that source.

For example:

Music     65

By default the following 6 sources are available:

CD, Radio, TV, Tape1 (or LP), VCR1, and LDisc.

The input and preset associated with each source depends on

To switch to Standby

●

Press Off on the front panel or

the remote. The display will show:

        .

If you have other Meridian 500 series equipment connected to

the surround controller using the comms lead, these units will

also switch to standby.

During normal use the surround controller should be left in the

Standby state. This uses a negligible amount of electricity and is

completely safe, but ensures that the components of the

surround controller operate at maximum efficiency from the

moment you start.

If you are not going to use the surround controller for several

days you should switch the unit completely off at the rear panel,

and disconnect it from the AC power supply.

To switch on from Standby

●

Press Source (front panel), or select a source by pressing the

appropriate source key on the remote: eg CD.

If the 541 Surround Controller is part of a Meridian system, it will

automatically switch on any other unit in the system, such as the

CD player.

To select a source

●

Press Source (front panel) until the display shows the source

you require, or press the appropriate source key on the

remote; eg CD.