Meridian Audio 541 Manuale Utente

If none of the standard settings exactly matches your

requirements choose the one that is closest, and then use the

541 Surround Controller’s configuration menus, called Config, to

make the necessary changes to the appropriate parameters.

The procedures for doing this are described in the following

sections of this chapter.

To specify the type of centre speaker

●

Switch off the surround controller, using the power switch on

the back panel.

●

Switch off any power amplifiers that are connected to the

surround controller.

●

Switch on the power again while holding down the Display

key on the front panel.

The display will show:

Config

●

Press 

> or < until you see a

display such as:

Centre  Norm

Specifying information about your system

●

Press 

A or V to step between the alternative options, as

shown in the following table:

Normal centre speaker; bass handled

by left and right main loudspeakers.

Wide-range centre speaker, with good

bass response.

No centre present; phantom centre

signal created by left and right main

loudspeakers.

When you have chosen the Centre option you want to use

proceed to the next step.