Mercedes Benz 2008 c300 Manuale Utente

135

Controls in detail

Driving and parking

SmartKey

왘

Turning off: Turn the SmartKey in the
starter switch to position 0 and remove
it.
The immobilizer is activated.

KEYLESS-GO* (Canada only)

왘

Turning off: Press the KEYLESS-GO
start/stop button to turn off the en-
gine.

With the driver’s door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch.

Releasing seat belts

왘

Press the seat belt release button
(

컄

page 106).

Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.

Warning!

Do not turn off the engine before the vehicle

has come to a complete stop. With the en-

gine not running, there is no power assis-

tance for the brake and steering systems. In

this case, it is important to keep in mind that

a considerably higher degree of effort is nec-

essary to brake and steer the vehicle.

In an emergency you can turn off the engine

while driving by pressing and holding the
KEYLESS-GO start/ stop button for approxi-
mately 3 seconds.

Make sure the seat belt retracts fully so that

the seat belt and/or latch plate cannot get
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim pan-
el. Such damage is not covered by the
Mercedes-Benz Limited Warranty.

Damaged seat belts must be replaced. Contact
an authorized Mercedes-Benz Center.