Mercedes Benz 2008 c300 Manuale Utente

왘

Prepare the vehicle as described 
(

왘

Take vehicle tool kit tray and vehicle 
jack out of trunk (

왘

Take the Minispare wheel from the 
wheel well under the trunk floor 
(

G

When jacking up the vehicle, only use the 

jack which has been specifically approved 

by Mercedes-Benz for your vehicle.

The jack is designed exclusively for jacking 

up the vehicle at the jack take-up brackets 

built into both sides of the vehicle. Make 

sure the jack arm is fully seated in the jack 

take-up bracket. 

The jack is intended only for lifting the 

vehicle briefly for wheel changes. It is not 

suited for performing maintenance work 

under the vehicle. To help avoid personal 

injury, use the jack only to lift the vehicle 

during a wheel change.

Never get beneath the vehicle while it is sup-

ported by the jack. Keep hands and feet 

away from the area under the lifted vehicle. 

Always lower the vehicle onto sufficient 

capacity jackstands before working under 

the vehicle.

Always firmly set the parking brake and 

block wheels with wheel chocks or other 

sizeable objects before raising vehicle with 

jack. Do not release the parking brake while 

the vehicle is raised. 

Make sure that the ground on which the 

vehicle is standing and where you place the 

jack is solid, level and not slippery. If neces-

sary, use a large underlay. On slippery 

surfaces, such as tiled floors, you should 

use a non-slip underlay, for example a 

rubber mat.

Do not use wooden blocks or similar objects 

to support the jack. Otherwise the jack may 

not be able to achieve its load-bearing 

capacity if it is not at its full height.

Be certain that the jack is always vertical 

(plumb line) when in use, especially on hills. 

Always try to use the jack on level surface. 

Never start the engine when the vehicle is 

raised.

Also observe the notes on the jack.