Honeywell T7047G Manuale Utente

T7047C,G ELECTRONIC THERMOSTATS AND REMOTE SPACE SENSORS

62-3050—3

Location

Locate the thermostat or remote sensor about 5 ft (1.5m)
above the floor on an inside wall where it is affected by
freely circulating air at average room temperatures.

Mounting

1. Loosen the cover locking screw and remove the

thermostat cover.

2. Run wire to the selected location; thread wire

through the semicircular hole in the thermostat; and
make connections to the T7047 (see the
Wiring section).

3. Four mounting screws are provided, two self-

tapping type for wall mounting and two for outlet
box mounting. Select the proper screws for the
application.

4. If air drafts occur through the wall opening,

eliminate with suitable material.

5. Fasten the T7047 on the wall or outlet box with

screws through the thermostat mounting holes. See
Fig. 2.

NOTE: Connect sensor wires to T-T terminals on

the thermostat cover assembly.

6. Replace the cover and tighten the cover locking

screw.

Fig. 2. Mounting the T7047.

Wiring

CAUTION

Electrical Shock or Equipment Damage
Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.

Fig. 3 through 7 show schematics and typical
connections. Also refer to instructions supplied with other
system components.

IMPORTANT

• All wiring must agree with applicable codes, ordi-

nances and regulations.

• To avoid electrical interference, which can cause

erratic performance, keep wiring runs as short as
possible and do not run thermostat wires adja-
cent to the line voltage electrical
distribution systems.

• Use shielded cable (Belden type 8762 or

equivalent for 2-wire and Belden type 8772 or
equivalent for 3-wire).

• The cable shield must be grounded only at the

controlled equipment case.

Fig. 3. Two T7047G Sensors providing a

temperature-averaging network for a T7100/Q7100

or T7300/Q7300 Thermostat/Subbase.

Fig. 4. Two T7047C Sensors and one T7047G Sensor

providing a temperature-averaging network for a

T7100/Q7100 or T7300/Q7300 Thermostat/Subbase.

THERMOSTAT

MOUNTING

TAB SLOT (2)

MOUNTING

TAB

(2 INSIDE

COVER)

MOUNTING

SCREW (2)

COVER

LOCKING

SCREW

OUTLET BOX

M17719

WALLPLATE

M3421

Q7300

T7047G1000

M3418

Q7300

T7047C

T7047G1000