Microboards Technology gx-1 Manuale Utente
• Assembly and Installation
6
Installing Ink Cartridges
Supported Ink Cartridges
The GX-1 Disc Publisher uses a single color ink cartridge. The part number for this cartridge is GX-
200HC. If other cartridges are installed, the GX-1 Disc Publisher will not function. These cartridges
are available from any Microboards reseller.
200HC. If other cartridges are installed, the GX-1 Disc Publisher will not function. These cartridges
are available from any Microboards reseller.
Refill kits or non-Microboards ink cartridges are not recommended for use in the GX-1 Disc
Publisher system. Use of these types of cartridges will cause the printer to fail. Use of these
types of cartridges will void the warranty.
Loading / Replacing Ink Cartridges
Cartridges can be changed while the GX-1 Disc Publisher is on, but it should never be turned on
without an ink cartridge in place.
without an ink cartridge in place.
The GX-1 Disc Publisher system ships with one GX-200HC color ink cartridge.
• Remove the front cover. The print cartridge cradle will be on the right side of the GX-1 Disc
Publisher, as shown below.
• Tilt the old cartridge forward to release the cartridge from the cradle, as shown in the inset
below.
• Lift the old cartridge out of the cradle.
• Remove the new print cartridge from its packaging and carefully remove the plastic tape.
• Remove the new print cartridge from its packaging and carefully remove the plastic tape.
Hold the print cartridge so that the copper strip is at the bottom.
• With the front of the new ink cartridge tilted down, slide the cartridge into the cradle.
• Tilt the front of the cartridge back up to lock the ink cartridge in place.
• Replace the front cover.
• Tilt the front of the cartridge back up to lock the ink cartridge in place.
• Replace the front cover.