Havis-Shields c-3619 Manuale Utente

 

 
DRIVER SIDE TRUNK CPU BRACKET:  

•  Remove driver side taillight. 

•  Position CPU Mount bracket so holes in bracket line up w/ taillight 

mounting holes. 

•  Reattach taillight through holes in bracket, then loosely attach nuts. 

•  Drill ¼” holes through vehicle trunk frame wall on opposite side of 

bracket. Use front side of bracket as a drill guide. 

•  Attach ¼-20 x ¾” Hex head bolts and ¼” Serrated nuts. 
•  Tighten all hardware. 

•  Mount CPU to Housing bracket using (4) 5mm-.8 x 10mm Hex 

head machine screws and washers. Be sure ON/OFF switch on 
CPU is turned ON at this time. 

•  This housing will be mounted to CPU Bracket after CPU cables 

are attached and wiring is complete. 

ATTACH CABLES TO CPU:   

•  Data cable from monitor to Display 1. 

•  Speaker cable box to port labeled AUX and Audio Out  

•  Ignition sense cable attaches to Speaker cable box. 
•  Route antenna cable to CPU 

•  Attach antenna connector to antenna cable 

•  Leave a service loop and wire tie antenna cable to CPU cover.   
•  Now that all cable is attached and wiring is complete attach CPU 

Housing to CPU bracket using pem-studs and ¼” serrated nuts 
designated for the specific components. 

•  CPU cables will face Rear Passenger Side taillight when mounted 

then loop down and around computer, up the inner wheel well, to 
the back seat wall. 

•  CPU must be level, both vertically and horizontally, to meet 

Motorola standards. 

•  Place CPU cover (CM93625) on mount using 10-32 x ½” Machine 

screw. 

 
 
 
 
 
 
 

C-3619_INST_12-08