Cadillac cts Manuale Utente

2. Press the Learn or Smart button on the garage 

door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
training mode.

Following this step, you have 30 seconds to 
start Step 3.

3. Return to HomeLink in your vehicle and firmly 

press and release the programmed HomeLink button
three times.

The rolling

-

code garage door opener should now

recognize HomeLink. You may either use HomeLink or
the hand

-

held transmitter to open the garage door.

If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1

-

800

-

355

-

3515, or on

the internet at www.homelink.com.

Canadian Owners: During programming, the hand

-

held

transmitter may automatically stop transmitting after 
two seconds. In this case, you should press and hold 
the HomeLink button (see Steps 2 and 3 under
“Programming the HomeLink Transmitter”) while you
press and re

-

press (cycle) your hand

-

held transmitter

every two seconds until HomeLink is trained.

Press and hold the appropriate button on HomeLink for
at least half of a second. The indicator light will come
on while the signal is being transmitted.

To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.