Fujifilm dr-i 90 Manuale Utente

1

Replace the battery with a new one.

2

Press the POWER button.

3

The flash is charging. Wait until “   ” stops blinking
and is displayed. (The flash takes approximately 6
seconds to charge.)

4

Remove the film, and load an unexposed roll.

5

Photograph at 0.5 - 1.0 m (1.6-3.3 ft.) or use the
AF lock so that the AF lamp is lit.

●

Remove the battery momentarily, then reload it.

1

Pull the end of the film out to the FILM TIP mark
and correctly load the film.

2

A picture can not be taken by pressing the shutter
release button in that condition. Open the camera
back a little and close it again.

●

Be sure not to move the 

 button while film is

loaded in the camera.

17
16
30

1

“ 

 ” symbol is blinking.

2

Power switch is not on.

3

Is “   ” blinking on the LCD?

4

“   ” is lit on the exposure counter.

5

Is the AF lamp blinking in the 

 mode?

●

Did you remove film without rewinding
it after you began photographing?

1

Did you pull the end of the film out to
the FILM TIP mark when loading the
film?

2

Did you insert the battery after loading
the film?

●

Did you operate the 

 button in the

middle of the film?

The shutter release won’t
trip.

The numerals on the ex-
posure counter blink.

After loading the film it re-
wound immediately.

After loading the film and
closing the camera back,
the exposure counter does
not advance.

The film rewound during
photographing.