INSTEON 2441 Manuale Utente
Thermostat Adapter Owner’s Manual (Rev 2.0+)
Page 6 of 13
Unlinking Thermostat Adapter from an INSTEON Controller
If you are going to discontinue using Thermostat Adapter, it is very important that you Unlink it from any
Linked Controllers. Otherwise, the Controllers will retry any commands repetitively, thus slowing down the
system.
Linked Controllers. Otherwise, the Controllers will retry any commands repetitively, thus slowing down the
system.
NOTE: If you Unlink Thermostat Adapter from a single button of an On/Off button pair, any Linked
commands for the Controller will be erased, even if the commands were Linked to separate buttons. You
will have to re-Link the commands you wish to continue using on your Controller.
commands for the Controller will be erased, even if the commands were Linked to separate buttons. You
will have to re-Link the commands you wish to continue using on your Controller.
The following will work for the most common INSTEON devices:
1) Set the Controller to Unlinking Mode. (For most Controllers, press & hold an On or Scene button for
10 seconds twice or the Set button for 3 seconds twice.)
You will have 4 minutes to complete the steps 2 and 3 before Unlinking Mode automatically times out.
2) Tap the Set button on Thermostat Adapter
3) Press & hold the Set button on Thermostat Adapter for 3 seconds
The thermostat display will flash all the LCD characters twice
4) Confirm that Unlinking was successful by tapping the buttons you just Unlinked from on the Controller
5) If there are any commands you would like to continue using with the Controller, re-Link them with the
prior settings. See Linking an INSTEON Controller to Thermostat Adapter.
Remotely Controlling your Thermostat
Recalling Mode / Set Points
Once you have Linked a Controller to Thermostat Adapter, you can recall the mode and set point settings
programmed during Linking by tapping the On button on the Controller.
programmed during Linking by tapping the On button on the Controller.
Temperature Set Point Adjustments
Some devices, such as RemoteLinc (#2440), have specific Dim and Bright buttons which can be used to
adjust the current thermostat set point up or down by a single degree.
adjust the current thermostat set point up or down by a single degree.
1) Recall a mode/set point by tapping an On button from a Linked Controller
2) Tap the Bright button to increase or the Dim button to decrease the temperature. Each button tap will
adjust the temperature by a single degree.
NOTE: While pressing & holding On or Off buttons does dim and brighten other INSTEON devices,
Thermostat Adapter will ignore those types of dim/bright commands to prevent “runaway”
temperature set points.
Thermostat Adapter will ignore those types of dim/bright commands to prevent “runaway”
temperature set points.