Lowrance radar and rim 200 operation Manuale Utente
7
Section 2: Radar Setup
This section will teach you how to prepare your radar for operation. Be-
fore you begin radar setup, the radar scanning unit, RIM 200 module
and display unit all must be installed and their cables connected.
WARNING:
WARNING:
Do NOT attempt to execute Radar Setup, while the ves-
sel is moving. Some motion from wind and wave action is
acceptable, but these setup instructions are NOT in-
acceptable, but these setup instructions are NOT in-
tended for vessels moving across the water.
Caution:
If you are unsure or do not understand the following instruc-
tions, it is strongly recommended that an experienced radar
technician handles radar setup and the installation of radar
technician handles radar setup and the installation of radar
hardware.
Getting Started
1. After turning on the unit, press
MENU
|
MENU
, then use
↑ ↓ to
S
YSTEM
S
ETUP
and press
ENT
.
Radar selected from Communication Ports menu (left). Radar Notice
(right) prompting users to leave radar in Standby Mode for 30 minutes
when activating radar for the first time.
2. From the System Setup menu, highlight
C
OMMUNICATIONS
P
ORT
and
press
ENT
.
3. Press
↓ to
R
ADAR
and press
ENT
, which will place an X in the radar
checkbox. The Baud Rate automatically will switch to 230400 and a
Radar Notice will appear.
Radar Notice will appear.