AudioControl LC-6.1200 Manuale Proprietario

40A – Replace these fuses only with the exact same style 

and Ampere rating. Disconnect 12V power before changing or 
inspecting the fuses.  

2.  Power Input Terminal +12V – This screw terminal connects to 

the +12V battery binding post of the vehicle. Use quality insulated 
wire, 4 to 0 AWG.

3.  Remote Power Input Terminal – This screw terminal connects to 

the 12V remote trigger output of some head units. When the head 
unit is turned on, then the LC-6.1200 will turn on. Alternatively, 
this terminal will output +12V if the LC-6.1200 turns on using GTO 
signal sensing.  This can be used to remotely turn-on power ampli-
fiers when the LC-6.1200 is awoken by the GTO.

4.  Power Input Terminal Ground – This screw terminal connects to 

a good ground connection on the vehicle. Use quality insulated 
wire, gauge 4 to 0 AWG.

5.  RCA Analog Line-Level Inputs – The line-level output from the 

head unit or factory-installed radios can connect here, so the 
LC-6.1200 amplifier  will receive the line-level audio signals. Do 
not use these inputs if you are using the speaker-level inputs.

6.  RCA Analog Line-Level Outputs – The line-level output can 

connect to external amplifiers or subwoofer amplifiers.

– The speaker-level output from amplifiers 

and factory installed radios can connect here. Do not use these 
inputs if you are using the RCA line-level inputs.

8.  Remote Control Connector – This connects to the ACR-1 remote 

level control.

Terminals – These screw terminals 

connect with speaker wire to your loudspeakers Make sure that 
the average combined speaker impedance does not dip below 
2 Ohms, or 4 Ohms in bridged mono mode.

1

2 3 4

5

6

8

9

7