Mitel Deutschland GmbH 68635RFP36U-01 Manuale Utente
SIP-DECT OM System Manual
306
7.27.1 CONFIGURATION OF A VIDEO USER ACCOUNT
An active user account with at least read and video permissions must to be configured, to use it inside
the OM Locating application.
the OM Locating application.
Please note:
If you have already configured the OMM’s “Full access” account within the OM
Locating application to access OMM service, you must change this account to the video-
enabled account created in this step.
enabled account created in this step.
7.27.2 CONFIGURATION OF USB VIDEO DEVICES
You configure video devices on the OMP’s
Video devices page (see section 6.9). The Video devices
page contains a list of known video devices and you can access the configuration window for the video
devices by double-clicking on an entry. Use the left side of the panel to enter a description of the camera
and its position. On the right side of the window, you can set the parameters for
devices by double-clicking on an entry. Use the left side of the panel to enter a description of the camera
and its position. On the right side of the window, you can set the parameters for
Resolution, Frame rate
and
Rotation.
Keep in mind that the chosen parameters for resolution and frame rate must fit the parameter
specifications of the camera device and that changes on this parameters are not possible on cameras
which have the state “started” (i.e. viewed in the OM Location application).
specifications of the camera device and that changes on this parameters are not possible on cameras
which have the state “started” (i.e. viewed in the OM Location application).
If a camera is installed in a way that the images which are sent by the camera are rotated (e.g. upside
down), use the parameter
down), use the parameter
Rotation to have the right view on the images inside the OM Locating
application. By setting the
Active option the video device is permitted to send images.
7.27.3 MONITORING WITH USB VIDEO DEVICES
Using the OMP monitoring mode for a video device opens a window with two tabs, the
General tab and
the
Status tab. On the General tab the actual configuration of the video device will be shown. On the
Status tab the actual status of the camera device will be shown. The tag is an internal identifier of a