Senao International Co Ltd 2511BG2PLUS Manuale Utente

 

7 

on the corresponding LAN port. 

Table 2-2 

To reset system settings to factory defaults, please follow the steps: 

1.  Power off the device, 
2.  Press the reset button and hold, 
3.  Power on the device, 
4.  Keep the button pressed about 5 seconds, 
5.  Release the button, 
6.  Watch the M1 LED, it  will flash 8 times and then M1 flash once per 

second. 

Two ports (LAN1and LAN2) connect with the bridge module board. 
Refer to the 2.1.3 Side Panel of Bridge for more detail. 

This item include two sub-items (To Power Amplifier and To Bridge) 
only use in when the power amplifier has been used. Refer to the 2.1.2 
Side Panel of DC-Converter for more detail. 

DC connector transmits 12 voltage power which connects with DC-IN 
in the side panel of bridge. 

LAN port connects to the DC-Injector which uses PoE (Power over 
Ethernet) technology. This port has the physical connection to the 
LAN1 port which locates in the side panel of DC-Converter. 

LAN port uses to connect to the other bridge has the physical 
connection to the LAN2 port which locates in the side panel of 
DC-Converter. 

Table 2-3 

 

 

 

Figure 2-2 Side Panel of DC-Converter 

 

Connects to the power amplifier use the SMA to SMA cable. 

Connects to the Bridge’s module board use the SMA to SMA cable. 

Connects to the LAN1 port which locates in the side panel of bridge. 

Connects to the LAN2 port which locates in the side panel of bridge. 

Table 2-4