Altronix STRIKEIT2 Dépliant

• StrikeIt2 operates one (1) 24VDC panic hardware device. It is designed to handle

the high current surge panic hardware locking devices demand. In addition, an 
auxiliary power output provides power for accessory devices such as card readers,
keypads, REX PIRs, electronic timers, relays, etc. 

• Input 115VAC 60Hz, 7 amp.
• One (1) NO trigger input.
• One (1) 23.2-24VDC lock output rated up to 16 amp 

for 300ms, 0.5 amp continuous hold current.*

• One (1) 23.2-24VDC filtered regulated auxiliary 

output rated @ 0.5 amp continuous supply current*
*Note: Total combined current for the outputs

may not exceed 1 amp.

• Built-in charger for sealed lead acid or 

gel type batteries.

• Automatic switch over to stand-by battery 

when AC fails.

• Maximum charge current .3 amp.
• When 4AH batteries are used, battery capacity 

for emergency stand-by is at least a 1/2 hour.

• Green AC Power LED indicates 115VAC present.
• Red LED indicates presence of 24VDC.

Rev. DSStrikeIt2 - L09I

UL Listed for Access Control Systems Units (UL 294).

CUL Listed - CSA Standard C22.2 No.205-M1983, Signal Equipment.