Philips D-Line Display BDL4235DL BDL4235DL/00 Manuale Utente

BDL4235DL

iii

•  Unplug the display if you are not going to use it for an extensive

period of time.

•  Unplug the display if you need to clean it with a slightly damp cloth.

The screen many be wiped with a dry cloth when the power is off.

However, never use alcohol, solvents or ammonia-based liquids.

•  Consult a service technician if the display does not operate normally

when you have followed the instructions in this manual.

•  The casing cover should be opened only by qualified service

personnel.

•  Keep the display out of direct sunlight and away from stoves or any

other heat sources.

•  Remove any object that could fall into the vents or prevent proper

cooling of the display’s electronics.

•  Do not block the ventilation holes on the cabinet.
•  Keep the display dry. To avoid electric shock, do not expose it to

rain or excessive moisture.

•  If turning off the display by detaching the power cable, wait for 6

seconds before re-attaching the power cable for normal operation.

•  To avoid the risk of shock or permanent damage to the set do not

expose the display to rain or excessive moisture.

•  When positioning the display, make sure the power plug and outlet

are easily accessible.

•  IMPORTANT: Always activate a screen saver program during your

application. If a still image in high contrast remains on the screen for

an extended period of time, it may leave an ‘after-image’ or ‘ghost

image’ on the front of the screen. This is a well-known phenomenon

that is caused by the shortcomings inherent in LCD technology. In

most cases the afterimage will disappear gradually over a period

of time after the power has been switched off. Be aware that the

after-image symptom cannot be repaired and is not covered under

warranty.

We declare under our responsibility that the product is in conformity

with the following standards:
•  EN60950-1:2006+A11:2009+A1:2010+A12:2011 (Safety

requirement of Information Technology Equipment).

•  EN55022:2010 (Radio Disturbance requirement of Information

Technology Equipment).

•  EN55024:2010 (Immunity requirement of Information Technology

Equipment).

•  EN61000-3-2:2006 +A1:2009+A2:2009 (Limits for Harmonic

Current Emission).

•  EN61000-3-3:2008 (Limitation of Voltage Fluctuation and Flicker)
•  EN 50581:2012 (Technical documentation for the assessment of

electrical and electronic products with respect to the restriction of

hazardous substances)

following provisions of directives applicable.
•  2006/95/EC (Low Voltage Directive).
•  2004/108/EC (EMC Directive).
•  2009/125/EC (ErP, Energy-related Product Directive, EC No.

1275/2008 and 642/2009 Implementing)

•  2011/65/EU (RoHS Directive) and is produced by a manufacturing

organization on ISO9000 level.