Juniper EX2500-RMK-4POST Manuale Utente
EX2500 Ethernet Switch Hardware Guide
14
Installing the EX2500 Switch in a Standard Equipment Rack
Installing the EX2500 Switch in a Standard Equipment Rack
This section describes how to install the EX2500 switch in a standard 2-post
19-inch equipment rack. For information about mounting the EX2500 switch in a
4-post rack, see “Installing the EX2500 Switch in a 4-Post Rack” on page 15.
19-inch equipment rack. For information about mounting the EX2500 switch in a
4-post rack, see “Installing the EX2500 Switch in a 4-Post Rack” on page 15.
Table 16 lists the parts included in the standard mounting kit.
Perform the following steps to mount the EX2500 switch in a 2-post rack:
1.
Use the M4 screws to attach a mounting bracket to each side of the switch, as
shown in Figure 4. Torque the screws to approximately 30 inch-pounds
(3.4 Nm).
shown in Figure 4. Torque the screws to approximately 30 inch-pounds
(3.4 Nm).
Figure 4: Attaching the Mounting Brackets
Table 16: 2-Post Rack Mount Kit
Description
Quantity
Brackets
2
M4 screws
8
M6 screws
4
M6 locking washers
4
M6 clip nuts
4
M6 cage nuts
4
CAUTION:
Do not stack other devices on top of the switch unit in the rack. The
mounting brackets cannot support multiple devices. Use mounting brackets to
secure each device to the rack.
secure each device to the rack.