Kern ECE 50K50Parcel scales Weight range bis 50 kg ECE 50K20 Manuale Utente

 

ECE-BA-e-1120 

4 

 

 

 
The balance you have acquired serves to determine the weighing value of the mate-
rial to be weighed. It is intended to be used as a “non-automatic“ balance, i.e. the 
material to be weighed is manually and carefully placed in the centre of the weighing 
plate. The weighing value can be read off after a stable weighing value has been ob-
tained.  
 
 

 
Do not use the balance for dynamic weighing. In the event that small quantities are 
removed or added to the material to be weighed, incorrect weighing results can be 
displayed due to the “stability compensation“ in the balance. (Example: Slowly drain-
ing fluids from a container on the balance.)   
Do not leave a permanent load on the weighing plate. This can damage the measur-
ing equipment.   
Be sure to avoid impact shock and overloading the balance in excess of the pre-
scribed maximum load rating (max.), minus any possible tare weight that is already 
present.  This could cause damage to the balance.  
Never operate the balance in hazardous locations. The series design is not explo-
sion-proof.   
Structural alterations may not be made to the balance. This can lead to incorrect 
weighing results, faults concerning safety regulations as well as to destruction of the 
balance.   
The balance may only be used in compliance with the described guidelines. Varying 
areas of application/planned use must be approved by KERN in writing.   
 
 

 
The guarantee is not valid following 

 

- non-observation of our guidelines in the operating instructions  

- use outside the described applications  

- alteration to or opening of the device  

- mechanical damage and damage caused by media, liquids  

- natural wear and tear  

- inappropriate erection or electric installation  

- overloading of the measuring equipment