John Deere Products & Services Cab A-11170 Manuale Utente

05-10324

June 2003

Mounting Instructions

John Deere 4100, 4110 and 4115

1. PREPARATION OF TRACTOR;

A. Remove grab handles from tractor fenders.

B. Disconnect battery power.

C. Remove rear warning lights from roll bar.

Attach warning lights to cab using (1) LH #7-

15662 and (1) RH #7-15661 dual light

mounting brackets. Secure lights to bracket

with; (See Figure 1C).

(4) 8mm x 25mm cap-screws

(4) 5/16” lock washers

D. Secure brackets to cab, on each side using;

(4) ¼-20unc capscrews

(4) ¼-20unc nyloc nuts

(8) ¼” flat washers

E. Install Dual Light Wire Extension Kit #8-

14639 to route wires into cab and down each

side of the interior cab wall. See Figure 1C

and 1E.

F. Remove side engine panels and hood.

2. INSTALLING THE CAB MOUNT PLATES;

G. Note: Loader brackets must be

purchased from John Deere in order to
mount the front cab mount plates.

H. Attach JD Loader Brackets to each side of

the tractor frame using and secure with;

(6) 10mm x 35mm bolts

(6) 7/16” lock washers

(4) 7/16-14unc x 1” long bolts

(4) 7/16” lock washers

(4) 7/16-14unc Nyloc Nuts

See Figure 2H.

NOTE 1C

Figure 1C

NOTE 1E

#8-14639

8MM x 25MM

Cap-screws

NOTE 1D

NOTE 1C

Figure 1E

7/16- 14unc x

1” Bolts

10mm x 35mm Bolts

Figure 2H

JD Loader

Bracket

Page 3