Viking Huskylock 936 Manuale Utente
—7—
Cut the thread
Tie the thread
Presser
foot lift
foot lift
Presser foot
Eye of the needle
1-7. Changing threads
The machine comes threaded with overlock
thread. To change thread follow the easy
threading as explained on page 16~18 or to tie
on:
1. Cut the thread in use near the thread spool
(in front of the telescopic thread stand). Place
the new thread spool on the spool pin and tie
the thread ends together.
2. Raise the presser foot with the presser foot
lift up to release the thread tension, so the
knot can easily pass through the thread ten-
sion discs.
3. Pull out the looper thread until the thread
knot comes about 10 cm (3” to 4”) behind the
presser foot.
4. When changing the needle thread, cut the
thread knot before it reaches the eye of the
needle to avoid bending the needle.
Thread net
In some cases cover the spool with the net
to prevent threads from slipping off the spool.
Slide on the net so that it covers the spool
entirely.
Spool holder
When using standard thread spools, place the
spool holders as shown to hold spool in place.
And prevent thread from getting caught on edge
of spool.
A
B