Viking Huskylock 936 Manuale Utente

—35—

A.

B.

C.

Right side of fabric

Adjusting screw

Material guide

There are two ways to sew a fl atlock stitch, with 

wrong sides folded together to create a decora-

tive look and with right sides folded together to 

create ladder stitch as used for lingerie.

1. Fold the material with wrong sides together. 

Then raise the presser foot, set the material 

so that it is under the needle, and then lower 

the presser foot. Set the stitch width control 

dial to (5-7). Sew, allowing the thread to loop 

off the edge (C).

4. Pull the material open (fl at) as shown. This 

method is not recommended for thin materi-

als. To adjust the position of the material 

guide, the same piece of material can be 

used to make a test sewing.

Note: For use of decorative threads in looper, 

decrease looper tension experiment, 

and program your settings in one of the 

memories for future use.

2. Adjust with the adjusting screw so that the 

needle moves down to a position 2.5~3.0 mm 

(0.1~0.12 in.) inside the folded edge of the 

material so that some of the stitching loops 

over the edge.

3. While guiding the material with your hand, 

sew at a constant speed.

Note: This foot will make it easier to sew along 

the folded edge without cutting the fabric.

2.5~3mm