Pearson 70 Manuale Utente

Optional Equipment

Unpack the printer and place it on the printer cabinet (a separate piece of 

furniture). Follow the instructions in the manufacturer's user manuals and install 

the printer as a parallel device, using the parallel interface cable to connect the 

printer to the network server or to a port located on the back of the scanner.
For cabling instructions, do the following (See Figure 3-5):

Attach the power cord.

•

Plug the female end into the back of the printer.

•

Plug the male end into the power strip.

Attach the parallel interface cable.

•

Plug the male end of the parallel interface cable into the port on the back 

of the printer.

•

Plug the other end of the cable into the appropriate port on the back of the 

network server or to a port labeled LINE PRINTER located at the bottom 

of the scanner's rear panel.

The optional Bar Code Reader is usually installed at Pearson NCS Manufacturing. 

It can also be installed in the field by a Pearson NCS technician. In both cases, the 

following cable connections must be performed as part of the initial installation.
There are two cables:

•

25-pin flat cable (I/O cable)

•

25-pin D-SUB to 9-pin D-SUB cable (Bar Code to PC cable)

The 25-pin flat cable has been pre-installed at Pearson NCS Manufacturing. You 

need to locate the 9-pin D-SUB end of the Bar Code to PC cable and plug it into 

the Com2 serial port on the back of the computer.

Ensure that the female end of the 25-pin flat cable is securely connected to the 

BCD board.

Ensure that the other end (also female) is securely connected to the 25-pin 

D-SUB end of the Bar Code to PC cable.

Plug the 9-pin D-SUB end of the Bar Code to PC cable into the Com2 port on 

the back of the computer.