Tatung TLM-1506 Manuale Utente

 

3

This equipment has been tested and found to comply with the limits for a class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio 

communications. 

However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television reception, which can 

be determined by turning the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

- Consult the dealer or an experienced radio/TV technician for help. 

Shielded interface cables and A.C. power cord, if any, must be used in order to comply 

with emission limits. 

Changes or modifications not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment. 

 

      The product must be installed according to the currently valid installation regulations for 

EMC to guarantee the designed use and to prevent EMC problems. 

      The device supplied with this manual is according to the EC, EMC Directive, 

89/336/EEC & LVD 73/23/EEC 

      Standard used for showing compliance with the essential requirements of the device: 

EN 55022 

EN 61000-3-2 

EN 61000-3-3 

EN 50130-4 

EN 55024 

LVD: EN60950-1 

 

1.  Do not modify the three-prong grounding type monitor power plug in any way. 

2.  Operate this unit only from the type of power source indicated on the label. 

3.  Do not block or cover ventilation openings on the back or bottom of the monitor 

cabinet.