Mikasa Automobile Parts MTX-60 Manuale Utente

Perform the scheduled maintenance procedures as indicated:

 Thoroughly remove dirt and oil from the engine and

control area.

 Clean or replace the air cleaner elements as necessary.

Check and retighten all fasteners as necessary.

 Check the spring box and bellows for oil leaks. Repair or

replace as needed.

Remove the fuel filter cap and clean the inside of the

fuel tank (Figure 11).

Remove and clean the spark plug, then adjust the spark

gap to 0.024~0.028 inch (0.6~0.7 mm).

Remove the air cleaner cover. Loosen and remove the 2

screws that hold the cover to the air cleaner assembly. If
the primary element (Figure 12) is dirty, wash it with
gasoline or kerosene. Then dip it in engine oil (SAE10W-
30) and wring the element so that 25 to 30 cc of engine
oil remains on the element.

FUEL FILTER

PRIMARY

ELEMENT

Remove the oil drain plug  on foot housing (Figure 13)

and drain the oil. Refill with approximately  0.69 qt. (0.65
liter) of 10W-30  SE, SF or higher grade motor oil. Oil
should be midway in sight glass. Break in oil should be
changed after first 50 hours.

Replace the fuel line  every 2 years even if there is no

visible damage.

Slide the throttle lever to the STOP position.

Drain any fuel including in the fuel hose.

Replace lubrication oil and apply grease to lubrication

points.

Cover the air intake on the air cleaner and the exhaust

outlet on the muffler.

Store unit indoors covered with plastic sheet in moisture

free and dust free location out of direct sunlight.

SIGHT GLASS
OIL DRAIN PLUG

OIL FILL PLUG