Manualsbrain.com
  1. Manuali
  2. Marche
  3. Cisco Systems
  4. 3.2
  5. Manuale Utente

Cisco Systems 3.2 Manuale Utente

Scarica
Pagina di 256
 
9-8
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 9      Configuring Radio Resource Management
Viewing RF Group Status
Using the CLI to Configure RF Groups
Follow these steps to configure an RF group using the CLI.
Step 1
Enter config network rf-network-name name to create an RF group.
Note
Enter up to 19 ASCII characters for the group name.
Step 2
Enter show network to view the RF group.
Step 3
Repeat this procedure for each controller that you want to include in the RF group.
Viewing RF Group Status
This section provides instructions for viewing the status of the RF group through either the GUI or the 
CLI.
Note
You can also view the status of RF groups using the Cisco Wireless Control System (WCS). Refer to the 
Cisco Wireless Control System Configuration Guide for instructions.
Using the GUI to View RF Group Status
Follow these steps to view the status of the RF group using the GUI.
Step 1
Click Wireless to access the All APs page (see 
Figure 9-2
All APs Page