Avaya Media Gateway G700 Manuale Utente

2. Enter the name and IP addresses for the LSPs.

3. Press F3 (Enter) when complete.

Before assigning an IP network region to a G700, you must define network region on the IP 
Network Region form. After a network region is defined, you can assign it to the various network 
elements (servers, gateways, IP phones).

The information you need to do this should be provided in your planning documentation. Use 
the system defaults if the planning documentation does not specify otherwise.

For a G700 with an S8300 as primary controller, there will usually be one network region, 
defined as 1. The procedure below uses 1 for the network region number as an example but the 
procedure applies for any network region number from 1 to 250.

CAUTION:

Defining IP network regions can be quite complex. For detailed information on 
the use and administration of IP network regions, see ‘‘Administration for Network 
Connectivity for Avaya Communication Manager, 555-233-504.’’

1. At the SAT prompt, type change ip-network-region 1.

The S8300 displays the IP Network Region screen.

change node-names ip

Page 1 of 1

                            IP NODE NAMES

Name              IP Address          Name                IP Address

default_________

0__.0__.0__.0__ _______________

___.___.___.___

node-10-lsp

192.168.1 _.50_

_______________    ___.___.___.___

node-11-lsp

192.168.1 _.51_

_______________    ___.___.___.___

__________ 

___.___.___.  _

_______________    ___.___.___.___

__________ 

___.___.___.  _

_______________    ___.___.___.___

__________ 

___.___.___.  _

_______________    ___.___.___.___