Atmel AVR2070 Manuale Utente
AVR2070
21
8240B-AVR-06/09
Table 5-1 ARM Telnet Menu Commands
ASCII Command
Description
a (lowercase)
IP Address. This is the current IPv4 address of the SAM7X.
A (uppercase)
IPv6 Address. This is the IPv6 address that has been self configured
or configured as a result of connecting to a true IPv6 router.
or configured as a result of connecting to a true IPv6 router.
b
Break. This allows the user to stop collecting data to the SD card.
c (lowercase)
Channel. This allows the user to change the operating channel.
C (uppercase)
Calibrate. Allows the user to calibrate the end node both single and
double set points.
double set points.
d
Dump. This shows the current content of the radio control registers.
f
Filename. This allows the user to set a new file name for data
collection on the SD card.
collection on the SD card.
i (lowercase)
Info. This provides a quick display of current radio settings including,
PANID, Channel, Short Address, etc.
PANID, Channel, Short Address, etc.
I (uppercase i)
New IP address. This allows the user to set a new IPv4 address. Once
entered the old one will no longer respond.
entered the old one will no longer respond.
l (lowercase L)
Log. This will resume data collection to the SD card. It is the corollary
to the “b” command.
to the “b” command.
n
Name. Allows the user to set the name of a node – 11 characters
max.
max.
o
Toggle node readings. Nodes report sensor readings on a periodic
basis (if APP=1). This allows readings to be displayed as they are
received. Does not affect collecting data to SD card.
basis (if APP=1). This allows readings to be displayed as they are
received. Does not affect collecting data to SD card.
p
Ping. Ping a user selected node.
Q
Quit. Quit the telnet session.
r
Read interval. Allows the user to alter the interval at which the end or
router nodes will report data to the PAN Coordinator.
router nodes will report data to the PAN Coordinator.
t (lowercase)
Table. Display a table of nodes and their relationships.
T (uppercase)
Touch. Provides a method to either ping or change the interval of all
nodes on the network.
nodes on the network.
w
Wake. If a node has been loaded with code that allows sleep
(SLEEP=1) then it must be woken up before it can respond to
commands such as “r”.
(SLEEP=1) then it must be woken up before it can respond to
commands such as “r”.
X
Max power. The PAN Coordinator is set to transmit at the lowest
power setting in demo mode. This turns up the transmit power to
+3dBm for the RF230 and the RF231. The Max power setting for the
RF212 is +8dBm for 900MHz operation and +5dBm for 700MHz
operation.
power setting in demo mode. This turns up the transmit power to
+3dBm for the RF230 and the RF231. The Max power setting for the
RF212 is +8dBm for 900MHz operation and +5dBm for 700MHz
operation.