Dolby Laboratories DP569 Manuale Utente

Pagina di 90
Model DP569 User’s Manual 
xi 
VIKTIGA SÄKERHETSÅTGÄRDER! 
Denna enhet uppfyller säkerhetsstandard EN60065. Enheten får ej utsättas för yttre åverkan samt föremål 
innehållande vätska, såsom kaffemuggar, får ej placeras på utrustningen." För att garantera säkerheten och 
gardera mot eventuell elchock eller brandrisk, måste följande observeras: 
o  Kontrollera att spänningsväljaren är inställd på korrekt nätspänning. 
o  Konrollera att säkringarna är av rätt typ och för rätt strömstyrka så som anvisningarna på enheten föreskriver. 
o  Enheten måste vara jordad genom anslutning till ett korrekt kopplat och jordat el-uttag. 
o  El-sladden som medföljer denna enhet måste kopplas enligt foljande: 
Fas—Brun    Neutral—Blå    Jord—Grön/Gul 
BELANGRIJK VEILIGHEIDS-VOORSCHRIFT: 
Deze unit voldoet aan de EN60065 veiligheids-standaards. Dit apparaat mag niet worden blootgesteld aan 
vocht. Vanwege het risico dat er druppels in het apparaat vallen, dient u er geen vloeistoffen in bekers op te 
plaatsen. Voor een veilig gebruik en om het gevaar van electrische schokken en het risico van brand te 
vermijden, dienen de volgende regels in acht te worden genomen: 
o  Controleer of de spanningscaroussel op het juiste Voltage staat. 
o  Gebruik alleen zekeringen van de aangegeven typen en waarden. 
o  Aansluiting van de unit alleen aan een geaarde wandcontactdoos. 
o  De netkabel die met de unit wordt geleverd, moet als volgt worden aangesloten: 
Fase—Bruin    Nul—Blauw    Aarde—Groen/Geel 
Fuse Information 
WARNING:
 
To reduce the risk of fire, replace fuses only with the same type and rating. 
The unit uses a universal switching power supply that handles the full range of nominal mains 
voltages between 90 and 264 VAC and any frequency between 50 Hz and 60 Hz. 
Check Main Fuse 
The Main fuse rating is: 
1 Amp, 250 V, 20 mm, time-lag fuse (for all operating voltages) 
WARNING:
 
The power to the unit must be off when the following steps are performed. 
Ensure that the main power cable to the unit is not connected to a power 
source. 
1.  Open the fuse compartment door in the AC power input housing with a small flat-blade 
screwdriver (see figure next page). Carefully pull out the fuse carrier. 
2.  Check that the fuse has the correct rating. The fuse carrier must be inserted into the 
compartment with the orientation shown in the figure below. Do not force the carrier into the 
compartment or both could be damaged.
 
3.  Snap the fuse compartment door closed. 
NL
S