Dolby Laboratories DP569 Manuale Utente
Model DP569 User’s Manual
Applications
3-6
Dolby Laboratories can also supply an interface kit to aid the installation of this system
into studios that use balanced digital audio connections. This kit is called the Cat. No. 541
cable kit and contains four BNC cables along with four impedance transformers.
into studios that use balanced digital audio connections. This kit is called the Cat. No. 541
cable kit and contains four BNC cables along with four impedance transformers.
3.2.2
Quick Start for DVD Authoring
This section describes the steps necessary to configure the DP569 for typical
operation. Refer to Figure 3-4 as necessary.
operation. Refer to Figure 3-4 as necessary.
Multitrack
Tape
PC
DP569
Main
Out
L/R
Ls/Rs
C/LFE
Digital
In
Digital
Audio
Outputs
Soundcard
Digital
Input
LTC
Out
LTC
Input
DP562
L/R
Ls/Rs
C/Sub
Audio
Outputs
Main
In
Soundcard
Digital
Output
PC running Dolby Digital
Recorder and
DolbyRemote software
Serial
Port
RS-485 or
RS-232
Figure 3-4 DVD Encoding System Block Diagram
1. After unpacking the unit connect the source audio to the digital audio inputs of
the DP569 using terminations as required. See Section 2.2.2 and 4.2.5, Digital
Audio Inputs.
Audio Inputs.
2. Install the soundcard in the PC and connect the main output of the DP569 to
the digital input of the soundcard.
3. Install and calibrate the DP562 Dolby Digital decoder as shown in Figure 3-4
and described the DP562 user’s manual.
4. Install the DolbyRemote and Dolby Digital Recorder applications on the PC.
See Section 5.2 and the Dolby Digital Recorder user’s manual.
5. Using the supplied cable, connect the COM port of the PC to the front panel
remote port of the DP569. See Section 5.2.3.