LG RAVENNA RDV3340 Manuale Utente

Your Ravenna™ gas insert is designed for maximum heat-

ing efficiency. Therefore, upon lighting of the main burner

the flames will be semi-transparent or “bluish.” After 10-20

minutes of operation the logs will heat up and the flames

will become a yellow/orange color.

Adjusting  the  insert  to  cause  the  flames  to  turn  orange

sooner  may  result  in  poor  combustion,  sooting,  and  a

hazardous situation. See Figure 17 showing proper flame

appearance.

When testing for proper operation - If an optional thermo-

stat is installed adjust it to its highest temperature setting.

Visually determine that main burner gas is burning properly:

i.e., no floating, lifting or flashback. Adjust the primary air

shutter(s) as required. Check for proper main burner opera-

tion at both high and low flame.

This insert has  been  painted with  StoveBright high  tem-

perature metallic stove paint. It leaves the factory dry to

the  touch,  but  finishes  curing  as  the  insert  is  used.  Fire

the insert four successive times for ten minutes each time

with a five minute cool down between each firing. Ventilate

the house during these first firings as the paint gives off an

unpleasant odor. It is recommended that persons sensitive

to an imbalance in the indoor air quality avoid the insert

during the curing process.

As the Ravenna™ gas insert is burning, a number of normal

operational sounds may be heard. The flow of gas through the

gas valve and orifice may make a rushing or whistling noise.

If this noise is objectionable, it can be reduced by turning

down the flame. Turning down the flame can reduce total

heat output by more than 30%. When the blower turns on,

the sound of rushing air may be heard. The blower sounds

may be reduced by adjusting the speed control located on

the blower assembly. Also, a slight clicking sound may be

heard as the gas valve or blower switch turn on and off.

Your Ravenna gas insert comes equipped with a 150 CFM

blower  with  a  variable  speed  control  and  an  automatic

temperature activated On/Off snap switch.

1. Plug the blower power cord into a grounded (three-prong)

outlet.  This  appliance  is  equipped  with  a  three-prong

(grounding) plug for your protection against shock hazard

and should be plugged directly into a properly grounded

three-prong receptacle. Do not cut or remove the ground-

ing prong from this plug.

2. After the insert warms up, the fan will turn on if the speed

control (located at the right below the firebox) is left in

the "ON" position. The fan will not operate until the insert

is warm.

3. Once the fan turns on, turn the knob to the desired speed.

No further adjustment is necessary.

4. If you do not wish to have the fan on, turn the knob until

it clicks into the "OFF" position.

If an optional wall thermostat is to be installed, install the

thermostat per the manufacturers instructions (provided with

the thermostat). Failure to follow manufacturers instructions

could result in a malfunction. Pay special attention to the

thermostat location requirements. If the location require-

ments are not adhered to the appliance, erratic operation

or failure may occur.

Do not mount the thermostat where it may be affected by:

•  Radiant heat from this appliance, fireplaces, sun or other

heat sources.

•  Drafts or dead spots behind doors or in corners.

•  Hot or cold air from ducts.