Westinghouse LCM-17W7 Manuale Utente

      8 

 

 
Analog Connection 
Connect a VGA cable (to the connector labeled “D-SUB”) and the enclosed audio cable (to the 
connector labeled “AUDIO IN”) from the back panel of the LCD monitor to your PC.     
 
Digital Connection 
Connect a DVI-D cable (to the connector labeled “DVI”) and the enclosed audio cable (to the 
connector labeled “AUDIO IN”) from the back panel of the LCD monitor to your PC.     
 

 
Connect the AC power cord to the monitor (to the connector labeled “AC IN”) and then plug it 
into a properly grounded AC outlet. 
 

 
Press the power button on the front of the LCD monitor. The LED light will turn green if a 
signal input is detected or it will be orange if no input is detected. 

 
 
 

 
Although a computer can detect the new monitor with the built-in VESA Plug & Play feature, 
the Auto Adjust function can be used to enhance the display.   
 

When using an analog signal, perform an automatic screen adjustment under the following 

conditions: 
 

- Using the monitor for the first time. 
- After having changed the system settings during use. 

- When connecting to a notebook computer, if the notebook is set so that it is displaying at 

the same time, the monitor may not display properly. In this case, change the computer 
settings so that only the monitor is displaying. 

 
To Perform the Automatic Screen Adjustment:     
Turn on the computer and monitor. Press the MENU button on the front control panel and then 

the OK button to start the automatic screen adjustment. The Auto Adjust message will be 

displayed. After a few seconds the best screen image will be displayed and the message will 

disappear. The automatic adjustment is now complete.