High End Systems High End LCD Controller for Studio Color Manuale Utente
4-10
Creating a Program
Studio Color LCD Controller
Creating a Program
This section gives you detailed step-by-step instructions for
creating a program. For a quick step-by-step overview, see
the section titled “Programming Guided Tour” on page 4-4.
creating a program. For a quick step-by-step overview, see
the section titled “Programming Guided Tour” on page 4-4.
Figure 4-2 below shows the programming keys that will be
referenced in this section.
referenced in this section.
Figure 4-2. Programming keys.
The Six Basic Steps
The programming process can be broken down into the six
steps listed below. Refer to the section titled “Using the
Construct Keys” on page 3-8 and to Figure 4-2 for
information not covered in this section.
steps listed below. Refer to the section titled “Using the
Construct Keys” on page 3-8 and to Figure 4-2 for
information not covered in this section.
Step 1: Make Sure the Controller is Ready for Programming
Figure 4-1 on page 4-3 shows how the controller looks when
it is ready for programming.
it is ready for programming.
Step 2: Select the Memory and Page
Use the Cursor
<Up>
and
<Down>
arrow keys to select a
memory. If this is your first program, use memory 1.
Standby key
Address/Preset key
Select key
Record key
Numbered address/preset keys
Cursor arrow keys
Page arrow keys
Construct arrow keys
ADVANCE
LIGHTW AVE
audio
level
erase
record
select
home
page
cursor
construct
PAGE
MEMORY
INTENSITY
MEMORY CARD
POWER
STANDBY
rate
USER
auto
PRESET
ADDRESS
1
3
5
7
2
4
6
8
1
2
3
4
5
6
7
8
slave
Studio Color