Pertech A470e Manuale Utente
A470e Users Guide
Pertech® 2006
9
The Document Stop limits the depth an inserted form can be placed into the Validation Slot. This
defines the validation printfield height. Printers are manufactured with the maximum printfield
setting of 2.16 inches but the dimension can be reduced to 1.44 inches by turning a slotted
screw in the bottom of the printer case counter-clockwise (CCW). Each CCW revolution raises
the document stop and decreases the printfield height 1/32” (.03125”) or .79375 mm. DO NOT
ATTEMPT TO ADJUST THE DOCUMENT STOP OUTSIDE THE PRESCRIBED LIMITS OR
DAMAGE TO THE PRINTER COULD RESULT. The validation form must be at least 1 inch taller
than the selected printfield.
Printfield Height
Ccw Rev
Inches
Mm
0
2.16
54.9
1
2.13
54.1
2
2.10
53.3
3
2.07
52.5
4
2.04
51.7
5
2.00
50.9
6
1.97
50.1
7
1.94
49.3
8
1.91
48.5
9
1.88
47.7
10
1.85
46.9
11
1.82
46.1
12
1.79
45.3
13
1.75
44.5
14
1.72
43.8
15
1.69
43.0
16
1.66
42.2
17
1.63
41.4
18
1.60
40.6
19
1.57
39.8
20
1.54
39.
21
1.50
38.2
22
1.47
37.4
23
1.44
36.6
CW
Clockwise rotating lowers the
document stop and increases the
print field.
CCW
Counter clockwise rotation raises
the document stop and decreases
the print field.
2.78"
3.6"
Print
Field
1" Min.
Validation
Printfield
Verification of the desired document stop setting can be made by printing a Configuration
Report Self Test on validation media and measuring the printfield. A Configuration Report Self
Test is initialized by turning the printer power off, pressing and holding the Paper Feed Button,
inserting a form into the printer and turning the power back on. The validation rollers can be
opened manually by raising the printer cover and pressing downward on the yellow sector gear
if the printer will not accept a form. The printfield dimension is measured from the top of the
first line of print to the bottom of the form.
Document Stop Adjustment