JL Audio SB-GM-VETC6/10W3V2 Dépliant

Specifications:
Enclosure Type: Sealed
Driver Type: 10W3v2-D2
Nominal Impedance: 4

Ω

Cont. Power Handling: 300 Watts

JL Audio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.

Included Hardware:
1) 3” x 3” Wax Square
1) 3/8-16 x 2-1/4” Socket Cup Set Screw
1) Mounting Support Plate
1) 3/8” x 1-1/4” Fender Washer
1) 3/8” Flat Washer
1) 3/8” Lock Washer
1) 3/8”-16 Hex Nut

10369 N. Commerce Pkwy, Miramar, Florida 33025-392      Phone: 954.443.1100     Fax: 954.443.1111

JL AUDIO 250/1

monoblock subwoofer amplifier

Amplifier Input Section

Input Sens.

Input Voltage

Low/High

Left Ch.

Right Ch.

Signal Sensing

Off/On

Output Mode

Full-Range/Low-Pass/High-Pass

Left Ch.

Right Ch.

Amp LP Filter

Mode/Slope

Off/12dB/24dB

Filter Freq. (Hz)

Bass Control

LF Boost (dB)

Off/30Hz

Infrasonic Filter

+1

+13

+3

+7

+10

Preamp Output Section

+12VDC

Ground

Remote

The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.

➔

➔

➔

STEP 7: (a)Run speaker wire form the amplifier’s
location to the Stealthbox’s® terminal and connect.

(b)Back out the Socket Cup Set Screw to expose
1-1/2”. Place the Stealthbox® into place and guide
the Socket Cup Set Screw through the drilled hole
from STEP 6.

STEP 8: Once the Stealthbox® is in place, from
the under side of the car. Place the supplied mount-
ing support plate, fender washer, flat washer, lock
washer and hex nut onto the exposed Socket Cup
Set Screw.

STEP 9: Thigthen the bolt assembly, do not over
torque.

➔

S B - G M - V E T C 6 / 1 0 W 3 v 2 ,   J L   AU D I O,   I n c   2 0 0 5

S h e e t   S K U # 0 1 1 1 9 8     R ev i s i o n 1 1 / 1 6 / 2 0 0 5  

ZR650-CSi

XR525-CXi

Front Location Driver Size:
10”

Applicable JL Audio Products:
TR,VR,XR & ZR650-CSi*

*mounting plate is needed
Rear Location Driver Size):
5.25”

Applicable JL Audio Products:
TR,VR & XR525-CXi