Viking VGSU5305BSS Istruzione Sull'Installazione

18

Replace the burner caps and grates. 

Note:

The narrow edge of grate goes toward center of unit.

• New units are cleaned at the factory 

to remove any visible signs of dirt, oil,
grease, etc. remaining from the
manufacturing process. Some stainless
steel parts may have a plastic protective
wrapper which must be peeled off. The
cooktop should be washed thoroughly
with hot, soapy water and then rinsed and
wiped dry to remove these film residues
and any installation dust or debris before
being used for food preparation.

A qualified installer should carry out the
following checks:

• Check top burner ignition. The low flame

should light at every port.

• Starting with the left 

front burner, turn the corresponding knob
to the HI position – see drawing for
proper flame height.

• Repeat steps for other burners.

Performance Checklist

Final Preparation

• All stainless steel parts should be wiped

regularly with hot, soapy water 
and with a liquid cleanser designed for
this material if build-up occurs. DO NOT
USE steel wool, abrasive cloths, cleansers,
or powders. If it is necessary to scrape
stainless steel to remove encrusted
material, soak with hot, wet cloths to
loosen the material, then use a wood 
or nylon scraper. DO NOT USE a metal
knife, spatula, or any other metal tool 
to scrape stainless steel. Scratches are
almost impossible to remove.

Final Installation

1

1

1

1

2

2

1

1-1/2”

(3.8 cm)

3/8”

(0.95 cm)