Viking VMOS201WH Istruzione Sull'Installazione

Cabinet or Wall Cutout

Provide an opening in the wall or cabinet as indicated

in figure

. The depth should be a minimum of 20-1/8"

(51.1 cm). If the Depth (C) dimension is greater than 21"

(53.3 cm), the outlet location may be in any area on the

rear wall. The floor of the opening should be constructed

of plywood strong enough to support the weight of the

oven (about 100 lbs.) and should be level for proper

operation of the oven.

Note: while the proper functioning of the oven does not

require that the opening be enclosed (with sides, ceiling

and rear partition), this may be required by local code,

and it is suggested that the local code be checked for

any such requirement.

Surface Mount Cutout Dimensions

* For flush mount dimensions please see installation template and

FLuSh MOuNT INSTALLATION on page 5-6.

CONVECTION

CONVENTIONAL

(A) Height

18-1/2"

(46.9 cm) Min.

16-3/4"

(42.5 cm)

Max.

17"

(43.2 cm)

(B) width

25"

(63.5 cm) Min.

24-3/8"

(61.9 cm)

Max.

24-11/16"

(62.7 cm)

Min.

20-1/8"

(51.1 cm)

Min.

20-1/8"

(51.1 cm)

(D)

Min.
Max.

6"
11-1/2"

(15.2 cm)
(29.2 cm)

(E)

Min.
Max.

4"
5"

(10.2 cm)
(12.7 cm)

ELECTRICAL OuTLET LOCATION: Outlet should NOT be in the

shaded area as indicated on figure 1. At the rear of the opening,

provide a 3-pronged, polarized, electrical outlet, 115-120 volt AC,

15 amp or larger.

DUCT (C)

DUCT (B)

SCREw (A)

EXhAuST DuCT ASSEMBLY: Insert the edge of DUCT (B) into the

hold lip of DUCT (C). Secure together by using a SCREw (A) provided

in the kit. See figure 2.

SCREw (A)

DUCT (A)-1

DUCT (BC)

SCREw (A)

EXhAuST DuCT ASSEMBLY: Position DUCT (A)-1 on the top of the

oven inserting edge of DUCT (BC) assembly into hole lip of DUCT

(A)-1. Tighten two SCREwS (A), securing DUCT (A)-1 to DUCT (BC)

assembly. See figure 3.

SCREw (A)

DUCT (A)-2

DUCT (A)-1

EXhAuST DuCT ASSEMBLY: Position DUCT (A)-2 on the top of the

oven and insert it into the hold lip of DUCT (A)-1. Secure DUCT (A)-2

to DUCT (A)-1 using two SCREwS (A) provided. See figure 4.

SCREw (A)

SCREw

(A)

DUCT (A)-3

DUCT (A)-2

EXhAuST DuCT ASSEMBLY: Position DUCT (A)-3 on top of the oven

and insert it into DUCT (A)-2. Secure DUCT (A)-3 using three screws

(A) provided. See figure 5.

Exhaust Duct Assembly