Frigidaire FPFU19F8RF Manuale Utente

Frigidaire

15

Mid-Level Lighting

(some models)

The mid level and upper level lighting comes

on automatically when the door is opened.

IMPORTANT

To disconnect power to the unit, unplug

the unit or switch the breaker that supplies

power to the unit to the off position.

Replace the old bulb with a bulb of the

same wattage.

To replace the light bulb:

1. Turn the temperature control to OFF and

unplug the electrical cord.

2. Remove the lens from the lamp housing

by unsnapping it from the lamp housing

using your fingers or a screwdriver. Be

careful not to break the locking tabs on

the lamp housing.

3. Replace the old bulb with a bulb of the

same type and wattage.

4. To replace the lens, snap one side of the

lens opening to the tab on the lamp housing.

Then carefully attach the other side.

INTERIOR LIGHTING

Mid-Level Lighting Light Bulb Removal

To Remove Light Lens

Press Tabs

in Direction Shown

Mid Level Lighting

Upper-Level Lighting

(some models)

The upper level lighting comes on

automatically when the door is opened.
To replace the light bulbs:

IMPORTANT

To disconnect power to the unit, unplug

the unit or switch the breaker that supplies

power to the unit to the off position.

Replace the old bulb with a bulb of the

same wattage.

1. To replace the light bulb, turn the

temperature control to OFF and unplug

the electrical cord.

2. Remove the light shield by pushing in on

the sides where the two tabs are located

in the back, and then rotate the light

shield down and out.

LED Lighting

(some models)

To Replace LED Lights:

1. Unplug the

power cord.

2. Remove light cover by

pushing up and out.

3. Hold the LED cover

with one hand and

pull the connector

with the other hand

while pressing the

connector latch.



NOTE

LED lights are in series, so if one is bad or

unplugged, several lights may not light up.

4. Replace LED

light and snap in

place assuring the

light is facing in

toward the unit

(inside fresh food).

LED Light Removal

LED Light Harness Removal

puerta entreabier ta

corte de energí a

reemplace el filtro de aire

mantenga presionado

para reinicia r

filtr o

de aire

modo

°F-° C

reinicio

de aler ta

traba

de cont ro l

mantener

presionado

Light Shield

Light Shield Tabs

3. Replace the old bulb with a bulb of the

same type and wattage.

4. When replacing the light shield, insert

the three tabs in the front of the light

shield into the slots in the control box and

then rotate the rear upward until the two

retaining latches lock into place.