GE JGBS04ER Manuale Utente

See 

Dimensions and Clearances in this section

for all rough-in and spacing dimensions. These

dimensions must be met for safe use of your range.

The location of the electrical outlet and pipe opening

(see Gas Pipe and Electric Outlet 

 may

be adjusted to meet 

 requirements.

. The range may be placed with O“ clearance
(flush) at the back wall and sidewalls of the range.

Do not 

 the 

range where it may be subject

to strong drafts. Any openings in the floor or wall
behind the range should be sealed. Make sure
the openings around the base of the range that
supply fresh air for combustion and ventilation
are not obstructed by carpeting or woodwork.

Your range, like many other household items, is

heavy and can settle into soft floor coverings

such as cushioned vinyl or carpeting. Use care

when moving the range on this type of flooring.
It is recommended that the following simple and
inexpensive instructions be followed to protect

your floor.

 range should be 

 on a sheet of plywood

 similar material). 

 the floor covering 

 the front 

 

 the area that the range

will rest on should be built up with plywood to
the same level or higher than the floor covering.
This will allow the range to be moved for cleaning
or servicing.

Depending on your range, you’ll find the model

and serial numbers on a label on the front frame

of the range, behind the storage drawer, kick

panel or broiler drawer.

● 

Phillips and flat-blade screwdrivers

● 

Pencil and ruler

● 

Two pipe wrenches (one for backup)

. 1%” open-end or adjustable wrench

 Nut drivers or wrenches: 3/16” and 1/4”

● 

Gas line shut-off valve

● 

Pipe joint sealant or 

 pipe thread

tape with Teflon* that resists action of natural
and 

 gases

● 

Flexible metal appliance connector (1/2” I. D.)

A 5-foot length is recommended for ease of

installation but other lengths are acceptable.
Never use an old connector when installing a
new range.

● 

Flare union adapter for connection to gas

supply line (3/4” or 

1/2” 

 1/2” I. D.)

● 

Flare union adapter for connection to pressure

regulator on range (1/2” 

 1/2” I. D.)

*Teflon: Registered trademark of DuPont

Remove all tape and packaging. Lift up the

 (on models with dual burners) and

remove any packing material under it. Make
sure the dual burners are properly seated
and level.

● 

Remove plastic film that covers some chrome

parts (around oven door, side trim).

● 

Take the accessory pack out of the oven.

● 

Check to be sure that no range parts have

come loose during shipping.

30