GE JGBS04ER Manuale Utente

 

Your surface burners are lighted by electric ignition,
eliminating the need for standing pilot lights with

constantly burning flames.

In case of a power failure, you can light the surface
burners on your range with a match. Hold a lighted
match to the burner, then turn the knob to the 
position. Use 

 caution when lighting burners

this way.

Surface burners in use when an electrical power

failure occurs will continue to operate normally.

The electrode of the spark igniter is exposed.
When one burner is turned to 

 all the burners

spark. Do not attempt to disassemble or clean
around any burner while another burner is on.
An 

 shock may result, which could cause

you to knock over hot cookware.

The surface burners on these ranges have standing
pilots that must be lit initially. To light them:

1. Be sure surface burner control knobs are in

the 

 position.

2. Remove the grates and lift the 

 up

(see the Lift-Up 

 section).

3. Locate the two pilot

ports and light each
of them with a match.

Knobs that turn the surface burners on and off are
marked as to which burners they control. The two
knobs on the left control the left front and left rear
burners. The two knobs on the right control the right
front and right rear burners.

NOTE: If the pilot is too high or low, you can
adjust it. See the Adjust the Surface Burner Pilots
If Necessary section of the Installation Instructions.

4. Lower the 

 Your surface burners are now

ready for use.

5. Observe lighted burners. Compare the flames

to pictures in the Problem Solver. If any flame
is unsatisfactory, 

 for service.

On ranges with sealed burners:

● 

The smaller burner (right rear position) will give

the best simmer results.

● 

The right front burner is higher powered 

 the

others and will bring liquids to a boil quicker
(natural gas installations only).