Adder Technology X200 Manuale Utente

The Adder X200 modules and CAMs are fully reconfigurable via flash upgrades 
using the KVM Firmware Uploader utility. 
during the upgrade you will be required to connect the X200 module directly to 
the serial port of a computer system using an optional cable. The upgrade utility 
will update the firmware of the X200 and also temporarily transform it so that 
it can update the CAM unit. Once completed, the X200 will return to its normal 
operation. 
The KVM Firmware Uploader utility is available from the Adder Technology 
website (

) and allows you to check the current revision of the 

X200 firmware.

1  Remove power from the X200 module. If one or both CAMs also need to be  

upgraded, ensure that they are connected to the X200 in the usual manner.

2  On the side of the X200 module, place switch 1 into its ON position.
3  Use the optional upgrade cable to link between the socket adjacent to the 

X200 switch block and a vacant RS232 9-way serial port of the computer 
system to be used.

1

ON

23

4

4  Apply power to the X200 module. The green indicator on the 

 

socket will flash to indicate upgrade mode.

5  On the computer, select the KVMUploader icon to run the upgrade utility. 

The KVM Firmware Uploader dialog will be displayed:

6  Click the Query Unit button to confirm that communication is possible with 

the X200 and to establish the existing firmware details.

  Note: The computer to which each CAM is connected must be powered 

  If the application cannot contact the X200 module, recheck the connection 

cable and click the Advanced... button to check that the correct serial port is 
being used. Change the serial port within the Advanced section, if necessary.  

  The results of the unit query will be displayed in the device/dongle Selection 

dialog:  

  The type and firmware revision of each discovered CAM will be displayed 

alongside the port number to which it is connected.