IBM Dock I Manuale Utente
Setting up the SCSI Controller Configuration
This section explains how to set up the SCSI controller’s
configuration.
configuration.
Default Settings
The configuration of the SCSI controller is preset to the default. The
default settings will serve most installations.
default settings will serve most installations.
The default configuration of the SCSI controller and ROM BIOS is
set up as follows.
set up as follows.
The SCSI controller uses no DMA channels and no I/O ports. All
operations are memory-mapped I/O.
operations are memory-mapped I/O.
The standard configuration uses 8K of memory space at address
CA00h in the system (the area reserved for ROM BIOS), and uses
Interrupt Level 11.
CA00h in the system (the area reserved for ROM BIOS), and uses
Interrupt Level 11.
Note: 8KB ROM BIOS is disabled when no SCSI device is installed.
Memory Address Range
CA00h–CBFFh
Interrupt select
IRQ11
I/O Address
None
Chapter 5. Using the SCSI Controller and Support Software
5-3
Title: C74AMST CreationDate: 06/23/93 17:09:07