IBM Dock I Manuale Utente
If your SCSI drives are new, using the appropriate IBM DOS or
OS/2 utility programs is the only step you need.
OS/2 utility programs is the only step you need.
The SCSI diagnostics utility helps you troubleshoot SCSI
controller and device problems through a series of menus.
Starting the SCSI Diagnostics Utility
This section explains how to run the SCSI diagnostics utility from
the Dock I Option Diskette to verify the configuration you just
installed.
the Dock I Option Diskette to verify the configuration you just
installed.
To start the SCSI diagnostics utility, do the following.
1.
Insert the Dock I Option
Diskette into drive A.
Diskette into drive A.
2.
Turn on all attached devices,
then turn on the computer.
then turn on the computer.
3.
In the main menu, select
“Diagnostics”. Then select “Test
SCSI Subsystems”. This screen
appears. Note that in this
screen the Dock I SCSI
controller is referred to as
adapter. Press Enter.
“Diagnostics”. Then select “Test
SCSI Subsystems”. This screen
appears. Note that in this
screen the Dock I SCSI
controller is referred to as
adapter. Press Enter.
Note
If you have not attached a
SCSI device to the Dock I
SCSI controller, the
diagnostics utility reports an
error that no SCSI host
adapters were not found.
SCSI device to the Dock I
SCSI controller, the
diagnostics utility reports an
error that no SCSI host
adapters were not found.
Chapter 5. Using the SCSI Controller and Support Software
5-21
Title: C74AMST CreationDate: 06/23/93 17:09:07