Pella 81CM0100 Manuale Utente

YOU WILL NEED TO SUPPLY:

TOOLS REQUIRED:

ŘComposite or Impervious shims/spacers  

(12 to 20)

ŘHigh quality exterior grade polyurethane or 

silicone sealant (3 to 4 tubes per door)

ŘGreat Stuff™ Window and Door Insulating 

Foam Sealant by the Dow Chemical Company 
or equivalent low pressure polyurethane 
window and door foam - DO NOT use high 
pressure or latex foams.

ŘWood blocking, 3/4" x 4" x 96" (2 or 3 pieces)
ŘScrews (#10 x 3-1/2")
ŘPella® SmartFlash™ foil backed butyl flashing 

tape or equivalent. 

ŘSill pan

ŘTape measure

ŘLevel

ŘSealant gun

ŘSquare

ŘHammer

ŘScrewdriver

ŘUtility knife

ŘWide jaw pliers

ŘReciprocating saw

Ř1/8" and 1/4" drill bit

ŘDrill

4&"-"/5

4&"-"/5

1A

A.  Remove the vent panel from the existing door frame. Check the dimensions of the 

existing door and the new door to make sure the new door will fit correctly. The opening 
must be 1/2" larger than the new door frame in both width and height. Measurements 
should be taken as follows:  
Width - measure the inside dimension of existing jambs.  
Height - measure from the subfloor or cement slab to the lowest point of the existing head. 
Confirm the flange will overlap the stucco by 1/2".