Toshiba 32HLV66 Manuale Utente
40
HLV66 (E/F) Web 213:276
Chapter 5: Using the TV’s features
Setting the sleep timer
You can set the sleep timer to turn off the TV after a set length
of time (maximum of 180 minutes).
of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press
[ on the remote control to set the length of time until
the TV turns off. Repeatedly press
[ to increase the time in
10-minute increments, or press B or b to increase or decrease
the time in 10-minute increments, to a maximum of 180
minutes.
the time in 10-minute increments, to a maximum of 180
minutes.
To set the sleep timer using the on-screen menus:
1
Press
Y and open the Setup menu.
2
Highlight Sleep Timer and press
T.
3
Press the Number buttons to enter the length of time in 10-
minute increments.
minute increments.
4
Highlight Done and press
T.
Note: When a power failure occurs, the sleep timer setting
may be cleared.
may be cleared.
To display the remaining sleep time:
Press
[.
Note: A message will display on-screen when there is one
minute remaining on the sleep timer.
minute remaining on the sleep timer.
To cancel the sleep timer:
Press
[ until it is set to 0 minute.
Displaying TV setting information
on-screen using RECALL
on-screen using RECALL
To display TV setting information on-screen:
Press
E on the remote control.
The following information will display on-screen
(if applicable):
(if applicable):
•
Current input (ANT 1, VIDEO 1, etc.)
•
If ANT 1 is the current input, either “CABLE” (for cable
TV) OR “TV” (for over-the-air broadcasts)
TV) OR “TV” (for over-the-air broadcasts)
•
Channel number (if in ANT 1 mode)
•
Digital signal strength indicator (bar graph in lower right
corner of screen; for ATSC signal only)
corner of screen; for ATSC signal only)
Note: The signal strength indicator will react to fading and
increasing signals.
increasing signals.
•
Remaining time on sleep timer (if set)
•
Stereo or SAP audio status
•
V-Chip rating status
•
Picture size
•
Video resolution
To close the RECALL screen:
Press
E again.
CH RTN
ENTER
EXIT
Navigate
Select
Back
Exit
Installation
Sleep Timer
PC Settings
Setup
PC Audio
No
Auto
2 Sec
HDMI Audio
Slide Show Interval
Sleep Timer
Enter total minutes until the TV
turns off automatically (Maximum
180 minutes)
1 2 0
Cancel
Done
Sleep Timer
120 Minutes
STEREO
CABLE
81-1
ANT 1
NC-17
Sleep Timer: 18 min.
Natural
480i
Sample RECALL screen
263237HLV66_EN.book Page 40 Thursday, June 22, 2006 1:32 PM