Honeywell VRX180 Manuale Utente

Instrument configurations can be stored to and loaded from floppy disk.  The front door must be closed.  
Configurations have filename extension .LNC.   

 

Table 4-69 describes the Load/Store Config prompts. 

STORE CONFIG TO 

DISK 

FILE01 CYCLE01 

DRYER01 PROD01 

RECORD01 TANK01 

UNIT01 LOOP01 

REACTR01 CONFIG01 

KILN01 VESSEL01 

CALIB01 WCHEM01 

PRESS01 FURNCE01 

DEMIN01 CONTRL01 

BATCH01 FERMTR01 

LEHR01 LINE01 

STRLZR01 OVEN01 

ZONE01 

Specify a filename and number (01-99) for the 
configuration.  Press Enter to store the configuration. 

LOAD CONFIG 

FROM DISK 

Select a configuration 
filename. 

First you must clear the instrument’s configuration memory.  
Press Enter to clear, or Menu to abort and exit the menu.  
Once the memory is clear, select a filename from the floppy 
disk.  Press Enter to load the configuration into the 
instrument. 

 

ATTENTION 

Only function blocks that have been programmed are loaded to the instrument.  Function blocks in the receiving 
instrument are not replaced unless the incoming function blocks are programmed differently.  For example, if the 
instrument has AI1 and AI2 programmed, and the configuration being loaded from the floppy contains AI3 only, 
then AI1 and AI2 are undisturbed on the instrument and AI3 is added.  If the configuration being loaded contains a 
different AI2 and a new AI3, then AI1 is undisturbed, AI2 is replaced by the different AI2, and AI3 is added.